PRODUCTS

Back to lists

Automatic Pressure Resistance Tester for Aerosol-Cans  【end of manufacture】

Model

AC-3MPA

Use/Good point

This apparatus is a tester that measures pressure resistance of an aerosol-can. The sample is prepared with supplying water into a can to give hydraulic pressure, then measuring the pressure at the points of deformation and fracture of the can. This apparatus is composed of the control part, the pressurizing mechanism, the pressure detection part, and the sample installation part, and this device has equipped with the LCD display for the setting and the LED indicator for pressure indication on the control part. Moreover, the PC output is available. It makes the analysis of pressure change easier if this tester is connected with PC.
The operation of measurement is fully automatic after pressing “start button”.

Spec

 AC-3MPA
Maximum pressure~2.5 MPa
Minimum readout value0.02 MPa
Maximum push-out water dosage100cc
Initial pressure(deforming pressure)~2.0 MPa(configurable)
Ultimate pressure(fracturing pressure)~2.5 MPa(configurable)
Pressurization speed~30kPa /sec
Retention time~60sec(configurable)
Manipulation panelLCD display (4 digits)
External outputUSB connecter
Safety devicesPressure safety valves, Emergency stop switch
Power sourceAC 100V 50/60Hz
External dimensionApprox. W900xD550xH1430mm